Need help/suggestion

[thefishingfreak]

You will never get that out beating on it. You'll just fatten the ends of the stainless pin making it even tighter.
I would first try an air chisel with a point tip. Hit it once quick and hard. If the pin doesnt budge get a giant C clamp and put a socket on the fixed end to press the pin into. Tighten it up as much as you can. Heat the crap out of the housing with a propane torch and rap the end of the threaded end of the C clamp, qiuck and hard with a 5 pound dead blow hammer .
If it still wont budge drill out the ends of the pin on each side progressively larger until it falls out

Tons of info on Google" etec lower trim pin removal"
Posted from my iPhone/Mobile device