|
Does your truck have a sliding rear window?
I used a piece of stiff foam about 3 " wide and as tall as my window opening, cut 2 grooves in it to match my window. I drilled three holes in it to match my rods and cut a horizontal slot to the holes so I could slide and snap the rods in (with line on them too). I put the foam in the open slider, then put the rods into the holes with the butts on my dashboard (reels on). I then close the slider into the slot cut in the foam. I them cut a piece of wood the width of the track that the slider fits in- in my case 1/2" - and long enough to stop the sllder from being opened. Lock the cab and it's all inside, un-takeable
|
Threaded Mode