|
B) Lubrication and cleaning
Lubricate and clean the tool holder spindle (12) and track (2) with WD-40. Remove the cover (27) by sliding to the right and apply WD-40 liberally to the tool spindle(12) and move back and forth to clean. Wipe excess WD-40 and dirt from the tool spindle (12). Simply spray WD-40 onto vee track (2) and move carriage (1) back and forth. Wipe excess WD-40 and dirt from track (2).
This was copied from the manual. As far as sharpening the cutter, I sharpened it with my wet sharpener. I jsut recently bought the diamond vee cutter and what a difference. No looking back
|
Threaded Mode