I read that thread you wrote about 5 minutes ago. I also plan on getting my hands on that article that you pointed out too.
I like to think of it more as an investment. In the long run it'll save me many bucks. Especially at the rate that I lose them. And I wanted to start making wood furniture anyway.
But Bernzy has a good point and I'll probably take that route first. Partly because I'm sure it'll take me a while to master the technique and because I NEED NEW PLUGS NOW! Ordering pre-turned blanks will get me going faster. I'm sure I'll like it though. I need another hobby for when I can't fish.
I've already got a lot of the tools, but I'll need a few more. A man can never have enough tools. I've already been to grizzly.com and ebay for a lathe. Haven't decided on a model yet. What model number would you recommend and are there special accessories that are required?
Thanks again.
Threaded Mode