|
If you make the sanding disk, consider making something to support the piece you are sanding. Without a steady rest, agressive sandpaper can pull the piece right out of your hand.
I dont have a sanding disk to photograph right now, I keep using them for jam chucks in bowl turning.
Motorfish, to make a drum sander, turn a cylinder on the lathe to the diameter you want, then while it is still in the lathe (not spinning), wrap adhesive sand paper around it. Now you have a drum sander. Just make sure the drum is tight between the centers.
Last edited by backcast; 10-05-2004 at 08:05 PM..
|
Threaded Mode