I make the normal nose loop on one end and then I stick the wire through the lip and get it situated, then I feed the wire through the plug and mark the wire about 3/8 of an inch outside of the hole. I then remove the wire, bend the wire back on itself and crush the bend almost flat. I make sure I can feed the bent wire through the end of the swivel and then I thread it through the plug and swivel. Next I drive a nail or an awl through the bend in the wire to open it up, I work it open until it is snug in the hole, then I fill it with epoxy. Works very well. Thanks Capesams
-Dave
Threaded Mode