Quote:
1. If you don't wire before you put your plugs on the wheel how do you keep them steady as they turn.
|
Insert the wire as you normally would. I.e., do the front loop and pass it through the body. Don't insert the loop so that it is tight with the plug. Put a bend in the side that comes out the tail. Will hang on the spinner just fine.
Quote:
|
2. If you force you grommets in the hook holes after sealing. isn't there a chance to damage the wood under the epoxy, allowing water an avenue to get under your paint. Wouldn't it be better to do a midway approach. Add the grommets seal then wire and add lip. [/B]
|
Add a little epoxy on the inside of the hole before inserting the grommet and don't man-handle the grommet
Jigman
Threaded Mode