Envirotex lite redo

[Diggin Jiggin]

Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there.

Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..

[Kadywampus]

Originally Posted by Diggin Jiggin

Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there.

Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..

Great idea , I've got the syringes but couldn't figure a good way to draw out of 16oz bottles .
Thanks

[Kadywampus]

Thanks for all the help from everyone . You guys are the best .
The amount and quality of information on this site is amazing .
Thanks again ,
Dan