Thanks for all the positive feedback from everyone , I owe everything I know about making plugs from this forum .
Just for the record , the top half of the plug is redwood which came from an old redwood fence and the botton was a piece of scap maple . I glued the pieces together with titebond 3 waterproof glue . Before gluing the halfs together I ran a vee router tip groove down the center of each piece creating a perfect center wire channel . I finished with e-tex .
Any questions about the glue holding up , .......... I've had a plug glued up and submerged in water for about a month now and it's still holding strong.
Thanks again
Dan
Threaded Mode