Just getting started

[Bay Stalker]

Originally Posted by Backbeach Jake

I use that BIN over my sealer (50/50 Helmsman Urethane/mineral spirits) and under my "Traditions" Acrylic color. Every time I deviate from my recipe there's an adventure. It's me, I know. That needle looks SUPER btw!

I will be using waterlox to seal my plugs. I was going to do 3 coats with sanding in between each when dry and light sanding before I prime. Then prime with the BIN primer and light sand again. When I get my airbrush I was going to use Createx paints. What suggestions would you have, good or bad. I am just learning and this is just what I decided on from my research. Not that it is set in stone. I am sure I will make mistakes, that comes with learning.