|
If you don't want to or can't heat your whole shop, try getting a heat lamp and reflector from a hardware store and place it in front of your curing station. Those things work really well in heating a small space, but don't put it too close to the plug as it will burn the epoxy (I found out the hard way). This does cut down on the cure time, though I have cured several batches in a 50 degree basement (it just takes longer).
It does sound like yours was a bad mix or out of proportion. One of the sponsors here sells graduated mixing cups. Easy to use and disposable and not much$. Another alternative is to use 30 minute epoxy in the dual syringe container. It distributes even amounts of resin and hardener so you don't have to worry about proportions, and it cures faster.
|
Threaded Mode