I've been pouring them into wooden molds but then you gotta cut them to fit and when I cut them I end up pinching the thru wire hole and then I gotta drill them again to reopen the hole. Then I gotta cut them to length. If I pour teh same diameter as the hole and the hole gets full of sealer then its too tight a fit.
I was just hoping to drill the holes to the right depth, put in a wire, pour into the plug, pull the wire and be done. Plus that way I could make whatever diameter hole I wanted.
You guys have not discouraged me anough, I may still play around with this.
Threaded Mode