Goose, they are basic one inch ID trailer bearings. Masing tape crossed my mind also, figured the ruberiser might be building a better mouse trap kinda thing. I've been cutting it with some tolluene (very bad stuff) and using it as flexament. Some thing everyone should think twice about before doing , or not doing at all.
There are some at Page's Hardware in Guilford, CT and an even better selection at Goody's in East Haven.
Saltheart, thanks if you find some larger ones I'm sure that would be better. I wasn't sure if the one inch ID was going to cut it until I saw your post .
|
Threaded Mode