|
Get a metal cutting band saw saw blade, as they are fine tooth, and dull the crap out of it with some steel. It will then cut nice and snug and save it for lips only. If you want a blade I can weld one up for you and dull the crap out of it for no charge. I'm good at it. If the epoxy does get in there I just use a thin, fine, coping saw blade holding by hand and run it thru a few times. I used to epoxy after I assembled but I much prefer to do it after the epoxy now. Maybe next year I will change my mind again. I also am very careful applying the epoxy around that area, not too thick. Of course I am now jinxed,.
Makes you stupid, LOL I like that one G.
|
Hybrid Mode
