|
now align and clamp the halves tightly and allow to dry 3-4 hours, overnight is better... if your wondering about the strength of this stuff, i took a unseald, glued , through drilled blank and soaked in water for 48 hours,I then put it onto my lathe and applied as much tail stock pressure as I could... it held, the then removed it from the lathe, drove my awl in to it so far, water was running everywhere out of the blank... it took a hammer and the vise to remove th awl.. the blank never split... back to the build.
once the blank/glue is dry, you will se the "ooze" on both edges, I remove it with the belt sander when I square up the ends, you can also remove it with a utility knife...
Like all plugs I make, there is a blue print, prior to the final blue print there are lots of scribbles and notes, I also make a "quick reference" index card that clamps on a magnet on my lathe.. my memory just isnt what it once was...
Continued in the next frame...
|
Threaded Mode