|
the first picture is of the jig I made specificlay for making this plug,it's been modified a few times but it serves several funtions, a dowel centerd 7/16" near the front holds the plug in place as I cut the lip slot, because the pikie 1 lip is so thin, I use the scroll saw instead of the table top band saw to cut this slot....
the lip slot is 5/16" deep in the plug, it would be too simple to mark it while I was laying out the plug, so I end up holding the lip to the plug most of the time...
once the lip slot is cut, install the lip andwith an awl, mark the center of the throgh wire...with a hand drill, drill a 5/32" hole at an upwards angle into the fron hook hole, this allows the use of a #1 swivel without it hanging down like an untucked shirt...
Making the V cut... the V not only makes the plug stream line, but by using a tight joint, the sides rattle as the plug swims along, slapping from side to side, this was by design, as I tried my best to make a rattle work on this plug, normaly, I instal them between the eyes, no could do here, just too narrow, so the next best thing.. a working body... this wouldnt be possible if the plug were not epoxied...
continued in the next frame:
|
Threaded Mode