|
Here is the darter I am trying . A nice Musso that George lent me. The one problem I did have was the aluminum plate kept galling a little bit on the cast iron table as you slid it along into the blade. I stoned the table like 3 times and broke every sharp edge, still was hard to push. I took it back to work and fly cut the fixture, still not smooth enough so i took a thin piece of polypropylene and took some 2 sided tape and adhered it to the bottom . Works like a charm, smooth as silk. Got the idea from my duplicator as I had to do that to the cutter sled. That all she wrote . Next week i work on the band saw fixture for the slope, angle.
|
Threaded Mode