|
as far as spinning rods i just use a length of the thru wire. Been using the same wire for years and I have heated it up lots of times to soften the epoxy so I can pull it off if it creeps into the holes and gets stuck. As far as the lips i have done it both ways but this year I will put the lip in and then epoxy, not assembled, just in place. Have not done any lipped plugs yet this year but got lots to do so I will go that method. If it doesn't go smooth then I will resort back to shim in the slot, remove before it gets stuck, and install after. I find a small, thin, fine tooth , coping saw blade will remove any hardened epoxy if the worst case happens thus allowing easy installation.
|
Threaded Mode