surface popper question

[WoodyCT]

Just a single straight cut on an angle? I'd freehand it on the bandsaw.

Leave a little extra to adjust your angle using the belt sander after cutting.


I just initialed your new plug Jeff!

[Charleston]

Sometimes I run it through the band saw. Other times if I have a bunch to do I set up my chop saw. Always leave a bit to clean up or adjust angle.
Make sure the angle is square to the eyes, etc.

[adson]

I run it thru the band saw.

but on most cuts I put a dowell about 8" long into the swivel hole so I can make sure I have it perfectly on its side

[WoodyCT]

Make a jig to hold cylinders while cutting or drilling by cutting a deep V groove down the length of a 12" piece of 2x4 using the table saw.