How do you cover your boat for the winter? - Striper Talk Striped Bass Fishing, Surfcasting, Boating

striperman36 · 09-24-2006, 10:18 AM

I am looking for options to cover my 21' this year.
I have on the fence about getting either it wrapped or looking for a temp shelter like Northeast covers.
What do people do and not have to , shovel snow off of it or pull the cover out of the boat repeatedly.

Let us know.

Bill

Raider Ronnie · 09-24-2006, 10:29 AM

I'll be winterizing the toilet and a few other things when it really starts to get cold in a month or 2 .
In the past I have pulled the boat end of dec or early jan.
I'll most likely be out of the water before dec 1 this year as I have made changes in my ins policy!
That about all I do, pilot house boats don't really need to be covered!
With the new ethanol gas, drain the tank and all lines & filters empty !!!

Clammer · 09-24-2006, 10:46 AM

Here we go again ><><

I don,t ////////// its in the slip 24/7

& the tin boat is in & out of the garage all winter -being used

capesams · 09-24-2006, 11:21 AM

shrink wrap is best...but the traveling guys that do it are getting out of hand price wise....cheaper to buy a tank..torch...roll of wrap..line if your going to hang onto your boat for years to come...if not, you can always sell off the stuff.

striperman36 · 09-24-2006, 12:16 PM

Any body own a gun? want to rent it out?

Bill

missing link · 09-24-2006, 12:46 PM

I made a frame that kind of shells the boat out of PVC then I cover it with a green tarp 20X30' if we get big snow I'll go out and use a broom to clean it off,I also have acess to it all winter this will be year 4 ,my fish boxes are not self draining and they have not filled up over the winter ,come spring the antifreeze is still in the fish box.
I disconnect the PVC in spring and put away till next year.
Always tie off your tarp ,bungee's stretch and snap
LinkSr.

piemma · 11-19-2009, 10:38 AM

Quote:

Originally Posted by Clammer

Here we go again ><><

I don,t ////////// its in the slip 24/7

& the tin boat is in & out of the garage all winter -being used

...and he ain't lying. I have seen Mike's boat FROZEN in the slip with the engine DOWN. He is a legend in our marina. Even the old crusty quahoggers think Mike is the BALLS!!!

maddmatt · 11-19-2009, 01:11 PM

throw an ext ladder over the motor to the bow then cover with tarp and hang milk jugs to keep the tarp in place.

15 min and done

MakoMike · 09-24-2006, 06:32 PM

I f you don't have cracks or other gel coat issues just let it be. Make sure it's blocked up at a good angle so the ice melt will run off and don't worry about it. Shrink wrap is more trouble than it's worth, between the boat geeting dirty and the cindensation inside, it isn't IMHO worth it.

slapshot · 09-25-2006, 06:50 AM

For several years I fought the wind blowing the tarp off the baot. Last year I took a long rope and wrapped it around the tarp (like a belt) just below the rubrail. I found that the wind couldn't get under the tarp to lift it off.

I build a simple frame out of 2x4s to shed all the water over the sides. Without the frame, the tarp sags to the floor and the boat fills with water. My Job Lot tarp is still going strong after 4 seasons.

likwid · 09-25-2006, 07:42 AM

save 1 gallon milk jugs to hold the cover down. never tie your cover to the trailer. fill em with water or sand and hang em every 3 feet or so.

BassyiusMaximus · 09-25-2006, 11:26 AM

I, too, go the tarp route, 20X30 and it has done me right for some time now. I build a T-type wood thing to place on the foredeck/bow and lay a 2x2 from my console to the bow, then from the console to the top of the outboard. Tie them together, put carpet or an old towel over the edges/corners of the 2x2's so the tarp won't get rubbed through, then run one long line from the "spine" out to the bowrail to the gunwales for additional support for the tarp then tie the grommets on the tarp off underneath the whole boat, has worked for almost 20 years. Lately, as an added precaution and because we have the extra rope, we take the rope and spin it around the whole boat so the tarp really won't come off. Doesn't take long and have never had a single issue. This is for the most simplest Center Console non-T-top boat, however, if I had any other boat, I'm sure I'd do the same thing and in no way would I pay the however-much-it-is to shrinkwrap the boat, had I the money then maybe, but I'd save it and tarp it up, it is only for what?, 4 or 5 months or so.

Nebe · 09-25-2006, 11:33 AM

Quote:

Originally Posted by likwid

never tie your cover to the trailer.

why?

likwid · 09-29-2006, 10:33 AM

Quote:

Originally Posted by Nebe

why?

Wanna see a boat learn to fly if we get the right storm?

Quote:

Originally Posted by beamie

Tying to the trailer is probably ok. Likwids point he is trying to make is never tie off to jack stands. This is an absolute no no. Stands get a little loose over time and if the wind catches the tarp and pulls the stands out....... over goes the boat.

Its been done to boats on trailers too (pull em right over.... esp. if the lines get loose)

Just run an extension under the hull to keep the edges against the boat so its nice and super tight instead of going to the trailer.

Also helps keep the mice and other critters out if its against the hull.

macojoe · 09-30-2006, 05:05 PM

I go thur a tarp every 3 or 4 years, been doing it like this for 15 years!!

I run a 2X4 from the bow to the stern, (takes 3 bolted toghter) I stand them on end for extra strength!

Cover with tarp and tie tight as you can with out pulling the grommets out!

Most tarps give out cause they are left to lose and allowed to flap in the wind. And sharp points!

I cover any sharp corners like the windshield with pipe insulation

Always dry all the time. If you make it tight and a good angle, the snow will slide right off and no problems!

blaruffa · 09-25-2006, 03:12 PM

I perfer shrink wrap, boat is always very dry inh the spring. I have done the tarp, but water always finds a way in the boat.

MTC · 09-28-2006, 07:25 AM

Shrinkwrap....

mekcotuit · 09-28-2006, 09:55 AM

Shrinkwrap

Uncle Matt · 09-28-2006, 01:17 PM

Shrink wrap once again this year. The portable garages cost more than I'm willing to spend or can afford right now.

zacs · 09-28-2006, 02:34 PM

I still want to know why I shouldnt tie tarp to trailer. I have been doing that for years. Well, not exactly tie, but bungee. Sometimes I have tied in a few spots up front, though.....

whats the scoop likwid????

ProfessorM · 09-28-2006, 03:03 PM

Maybe it will rip if it get's loaded with percipatation ?

BigBo · 09-28-2006, 03:35 PM

I always tie to the trailer.

I just got done putting the light duty tarp on to keep the leaves out. I hate a boat full of decaying leaves.

beamie · 09-28-2006, 04:39 PM

Tying to the trailer is probably ok. Likwids point he is trying to make is never tie off to jack stands. This is an absolute no no. Stands get a little loose over time and if the wind catches the tarp and pulls the stands out....... over goes the boat.

slapshot · 09-29-2006, 10:31 AM

As mentioned above, several of us succesfully use tarps. I purchased mine 4 seasons back. It does not have a tear, it does not let a drop of water in the boat, and I only paid 79 bucks for it once.

Too many other unavoidable costs in boating to fork over 200-300 bucks for shrink wrap every year when I can pay next to nothing and still have access whenever I want to the boat without cutting into a shrinkwrap job. I'll take some pics in December when I pull the boat out of the water.

I've never gotten a scratch from a tarp. And if I have to replace the tarp in a few years I will still have paid less than one season of shrink wrap costs.

ProfessorM · 11-02-2009, 01:48 PM

I would still build a pvc frame under it. I have a custom cover that came with boat but if I just put it on it would get full of snow in low spots and rip sure than sh((*^&*t. With snow I need the extra support. Mine is a walk around though.

Offshore24 · 11-02-2009, 02:02 PM

I build my covers as tall as possible so they shed snow readily. Three colums supporting a ridgepole, all out of 1x3 strapping. The columns have plywood bases. I use clothesline to hold the ridgepole in place and support the tarp. Put the old tarp on first and a new one over it. Wrap them around the boat. Only thing that's ever gone wrong was when a tree fell on the boat in a spring wind storm. A new tarp is $50 every 3 or 4 years. More clothes line is $10 a roll. Cover costs me less than $20 a year and it basically recyclable. Shrinkwrap is great if you can afford it but a waste of resources IMO.

InTheHole · 11-02-2009, 02:34 PM

I reuse my shrink wrap, this will be year #4. Put the same basic frame together each year, start from the front and pull the wrap back to the rear. Tie it together with plastic strapping from 1 side - under the hull to the other side. No issues so far and the boat is a lot cleaner in the spring.

striperman36 · 11-02-2009, 02:54 PM

Shrinkwrap online, I am down to about 4.50 a foot. I don't reuse it.

Interested in PRBuzz's solution as that would fit year round

PRBuzz · 11-02-2009, 03:12 PM

Quote:

Originally Posted by striperman36

Interested in PRBuzz's solution as that would fit year round

Although I have not done it, supposedly you can tow while the cover is in place.

Takes about 10min to remove cover and maybe 2-3X that to put on. I have not tried to do in a hurry as the cover has only been on the boat 2X: once for practice and once for the entire winter. The 3rd time is quickly approaching, maybe early Dec.

striperman36 · 11-02-2009, 06:20 PM

Quote:

Originally Posted by PRBuzz

Although I have not done it, supposedly you can tow while the cover is in place.

Takes about 10min to remove cover and maybe 2-3X that to put on. I have not tried to do in a hurry as the cover has only been on the boat 2X: once for practice and once for the entire winter. The 3rd time is quickly approaching, maybe early Dec.

Not for towing but for sideyard docking