Putting New Guides on a Blank

[Crafty Angler]

Just picked up a pair of matching J Kennedy Fisher 8' boat rods, both wrapped conventional and they're pretty danged nice - I've been thinking of having one redone as a spinning rod so I'd have one of each.

Obviously, ya gotta flip it over when you do it to get the spine correct - any other things to watch out for? Or is it just not advisable -

What do you think a reasonable fee for doing it might be - assuming I'm probably just gonna go with Fuji guides?

Also - what do you have to do to remove the reel seat - is it a matter of Dremeling off the old one?

Sorry for the multiple questions - never had this done with a rod before, wanna make sure I've got my bases covered.

Thanks in advance -

[stcroixman]

Call wickford rodworks

[Crafty Angler]

Thanks, stcroixman -

I guess I'm just trying to determine the degree of difficulty in converting a convench to spinning -

[Goose]

as far as the reel seat goes...you should have no problem if its metal but if its graphite and done right you may a have a difficult time. also, your going to have to strip and paint the blank.

I done bunch of rods like that but imo your better off buying a blank and compontents because its very time and labor consuming and that add$ up. not to mention it may not have the action you think it might.

[canalbeach]

[QUOTE=Goose;644576]as far as the reel seat goes...you should have no problem if its metal but if its graphite and done right you may a have a difficult time. also, your going to have to strip and paint the blank.

Goose why would you have to strip and paint the blank?

[striperman36]

Most rods will show wear where the guides and reelseat are.

You can do this, but I would agree with others on this post, sell them and get a spinner made. much less hassle

[SeaWolf]

most production rods are built on the straightest axis and not spined, as many custom rod builders would do. you may be fine just throwing guides on it as is because on a spinning rod, spine is not as important as it is on a standard, non-spiraled conventional rod. on a spinning rod, the line is on the bottom of the rod, so it is already stable under load. as far as guides, stick with fuji's. if you want to keep prices down, go with hardloy or alconites.

[RIROCKHOUND]

I second Wickford Chuck;
Bob does great work!
if he can keep guide spacing and such the same cosmetics shouldn't be too bad....

[Goose]

You want to strip and paint because you always want the blank to look knew.. you shouldn't be able to recognise it was ever messed with.

[Crafty Angler]

Thanks, Goose