Quote:
Originally Posted by Rmarsh
Stairs again......nothing special about these....but most of the stairs we do use 5/4" thick treads which finish out to just over 1"thick. To save on material costs we are switching to 3/4" thick....when the oak cove moulding gets applied under the tread nosing it gives the appearance of being thicker. It is so much easier to cut and fit these thinner treads too!
|
I always liked the 5/4 treads. I think they are stronger and give a better look. Are those rabbitted risers your using? If so I assume the tread has a tapered piece on the back edge so it fits in nice and tight? Nice system they are. Used to get all my millwork from van lumber out of bellingham mass.
Threaded Mode