how to make a airbrush manifold.

[smitty919]

--------------------------------------------------------------------------------

how to make a airbrush manifold.

well i just got back from buying my 3rd airbrush and was thinking how much of a pain its going to be to keep switching the hose on the compressor.

so i went to homies and got some 1/4" gas pipe and made a manifold out of it.

i used 5 2" 1/4 nipples 2 1/4 tee's and 1 1/4" 90.

all it cost to make was $6.00 now i have 3 guns ready to go .

[pbadad]

Nice job. I purchased a 3 way quik disconnect from Harbor freight. Works great.

[Striperknight]

What fly vise do you use? Did you find them cheap someplace?

[smac]

nice set up.

Why is it that the wall behind your desk is not 300 different colors? You using a down draft table?

[GattaFish]

Hope you have a dryer prior to those black malleable fittings and black steel nipples because if you don't it WILL rust on the inside,,,,

[Bay Stalker]

good idea but.......

Like others said RUST
Even with the dryer I would hate to have to worry about the BI flaking off on the inside


for $15 I would get this



or for $6.

[GattaFish]

Where can you get the chrome manifold,,,,???