I set up the gosa 6K at 23" from the butt, did the table top bit to set the choke point and low and behold there is no choke point.... see below
went with the 27X and a KW8 choke, then set KW's down the reduction line,,, the two stripper locations I ended up with have me puzzled, which is very easy to do seeing as though I pretty much don't know what I'm doing...:-)
also the 20 and 16 hit the reduction line but end up not quite inside what I call the KR COF
if I have a question here,,, getting dizzy,,,,, are either of the stripper locals acceptable,,, ?
gsb1201_m_table top choke.pdf
gsb1201_m_27X method.pdf
I realize this is probably way over kill with the CAD and all but,,,, I figure it's a good start, plus I'm sitting here waiting for my plotter to complete a map update....
Threaded Mode