Hey Nightfighter

[Higgie]

Nice t man many ways to thru drill depending on your setup sharp bits and patience are key. Feed and speed. I started going up a size in drill bits for hard woods last year and accuracy def increased
Posted from my iPhone/Mobile device

[Rockfish9]

Originally Posted by Higgie

Nice t man many ways to thru drill depending on your setup sharp bits and patience are key. Feed and speed. I started going up a size in drill bits for hard woods last year and accuracy def increased
Posted from my iPhone/Mobile device

All of this^^^ I also.made a jig to hold the plugs that I drill on the drill l press perpendicular so the drill and plug are on the same plane,these are the ones I have cut the ends off, like darters,most are drilled on a lathe before I cut off the ends, IMHO. the larger size drill bit also aids in the sealer getting into the plug easier, and drying...
Posted from my iPhone/Mobile device

[t_man7]

Originally Posted by Rockfish9

All of this^^^
IMHO. the larger size drill bit also aids in the sealer getting into the plug easier, and drying...
Posted from my iPhone/Mobile device

Thanks guys, I didn’t think about that. I have been reading your articles on noreast.
Tommy