METHODS FOR SHRINK WRAPPING
What seems to be everyone's take on installing shrink wrap?
Here's mine: once determine for diameter of wrap , whether over blank or underlayment tape , I use either contact cement or spray adhesive to allow for adhesion on wrap especially between the spaces of the cord X design or spiral grooves. Also especially on the bottom hand area to assure a bond over the time used.
I carefully use a heat gun on the low setting and spin by hand the rod and move the gun as it shrinks not to keep it on one spot too long . I'm always concerned of overheating the blank materials. I figure if I can touch the area and hold my hand on it for a few seconds , it's at a safe temp.
I see other methods i.e. heat pump, hot water, hair dryer etc. Your thoughts?
|
Threaded Mode