slowly getting back into it

[stripercrazy]

after a poor fall, i've not been thinking much about plugbuilding but i'm slowing starting to look forward to plugfestand seeing everyone i hit the lathe for the first time last week and tried a jointed danny hope everyone has a great holiday season

[Chunkah]

Nice stripercrazy!

I've been slacking as well but the itch is coming back too. I make a jointed Danny very similar to that, except the middle is a bit thicker. With a pikie 3 lip it gets down real good and does nicely at the breachways.

Good luck building!

[stripercrazy]

wow 8 inch jointed danny, nice .breachway killer for sure, i like the size.

[UserRemoved1]

Eddie

Very nice. Was thinking about you last week, mentioned to Denise I haven't seen you in a while. Very Merry!

Chunkah your range of motion will be limited with that center cut like that. If you sand a taper on both sides I think you'll get more action when you run it slower.

[iamskippy]

He may also be able to get into that loop with some pliers and modify it so the tail gets back further
Posted from my iPhone/Mobile device

[Chunkah]

This is with a danny lip.