GUIDE FEET PREPPING

[ed morini]

I do the same as you Bill. but I have always worried about the stainless left bare and I usualy coat the feet with nail polish. I have found when working with stainless that unless the stainless has contact with water and forms an oxide coating, it will corrode. I have seen this working on boats where the screws were counter sunk, plugged and were gone in a couple of seasons.

I have seen rods with rust in the wraps and can only wonder if the above was the case. I think the toatal encapsulation of the guide and wrap do not allow for the reaction to take place, hence the nail polish. I have a bunch of rods out there and so far so good.

Ed