What would I use to drill out the end of a popper ? I tried a drill bit but not having any luck, I was told to use a cuts all .But I cant find it any where ,any help would be appreciated,
They have the Cutzballs at Woodcrafter. Many have them right in the shop.Takes some practice but works nice. Just run them in reverse for best results.
As far as using a drill bit for the cups well you need to go big say 5/8 to 3/4 qnd the plug needs to be held at an angle so your cutting into the meat of the plug. you can either cut the angle ist or after depending what you want for a cup. I learned that trick from my shop teacher when
i was a kid. I'd post a couple pics but can't seem to get that to work. Not all that good on the computer.try it on a couple peices of dowel. The center hole works good as a guide. A v block helps clamped to the drill press. I used to use a wood clamp to hold them in place.Hope this helps. Ron
Linear Mode
