Quote:
Originally Posted by Clammer
BOB
jUST GET A PIECE OF 3/4 PLYWOOD OR THE HEavy plastic we use for the sides for digging ............. take two pieces of the same material put one each down both sides with a space large enough to drop the main piece & you can drop it in when the motor is down & just pull it out when your going to tilt the motor ,
The ruggeder pastic is best / it doesn,t bens, warp , etc & slides nicely ><><><>
|
piscators contender has this sort of setup. not sure if its factory or an addon but it's a pretty good solution. maybe he'll put up a pic if it's not covered up