Transom Retro

[Clammer]

BOB


jUST GET A PIECE OF 3/4 PLYWOOD OR THE HEavy plastic we use for the sides for digging ............. take two pieces of the same material put one each down both sides with a space large enough to drop the main piece & you can drop it in when the motor is down & just pull it out when your going to tilt the motor ,
The ruggeder pastic is best / it doesn,t bens, warp , etc & slides nicely ><><><>

[JFigliuolo]

Originally Posted by Clammer

BOB


jUST GET A PIECE OF 3/4 PLYWOOD OR THE HEavy plastic we use for the sides for digging ............. take two pieces of the same material put one each down both sides with a space large enough to drop the main piece & you can drop it in when the motor is down & just pull it out when your going to tilt the motor ,
The ruggeder pastic is best / it doesn,t bens, warp , etc & slides nicely ><><><>

that's kinda what I was talking about.

[niko]

Originally Posted by Clammer

BOB


jUST GET A PIECE OF 3/4 PLYWOOD OR THE HEavy plastic we use for the sides for digging ............. take two pieces of the same material put one each down both sides with a space large enough to drop the main piece & you can drop it in when the motor is down & just pull it out when your going to tilt the motor ,
The ruggeder pastic is best / it doesn,t bens, warp , etc & slides nicely ><><><>

piscators contender has this sort of setup. not sure if its factory or an addon but it's a pretty good solution. maybe he'll put up a pic if it's not covered up

[fish4striper]

Yeah im sick of mine also always wet, plan on doing this overwinter to my boat.

Originally Posted by niko

piscators contender has this sort of setup. not sure if its factory or an addon but it's a pretty good solution. maybe he'll put up a pic if it's not covered up

Posted from my iPhone/Mobile device