Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Van · 04-08-2014, 03:10 PM

Striperman, the engine is an etec, probabaly the same as johnsons.
It would be great to see what it says. This is corroded in place.

I did use a punch but did not add heat. Not sure I am getting enough
force on it, but i don't want to break anything either. That sounds like a good option. It will be painted anyway.

I am going to get some PB blaster in there too. The WD didn't help much.

04-08-2014, 03:10 PM	#8
Van zoom iTrader: (0) Join Date: Apr 2002 Location: Quincy Posts: 4,145	Striperman, the engine is an etec, probabaly the same as johnsons. It would be great to see what it says. This is corroded in place. I did use a punch but did not add heat. Not sure I am getting enough force on it, but i don't want to break anything either. That sounds like a good option. It will be painted anyway. I am going to get some PB blaster in there too. The WD didn't help much.
	~..~..~.. ><((((º> Things done at the last possible minute are done with the greatest possible information. Procrastination is, therefore, the most efficient means of doing things.