Need help/suggestion

[Van]

Striperman, the engine is an etec, probabaly the same as johnsons.
It would be great to see what it says. This is corroded in place.

I did use a punch but did not add heat. Not sure I am getting enough
force on it, but i don't want to break anything either. That sounds like a good option. It will be painted anyway.

I am going to get some PB blaster in there too. The WD didn't help much.

[BEETLE]

Ya oops - stainless not so good to cut with sawzall

Kroil &
Heat &
patience

[Raider Ronnie]

Originally Posted by BEETLE

Ya oops - stainless not so good to cut with sawzall

Kroil &
Heat &
patience

I would go the cut suggestion route, cut and work 1 piece out at a time but instead of a sawzall I would use a 1/32 thick x 6 or 8 inch cut off wheel on a 4 1/2 electric grinder.
Posted from my iPhone/Mobile device