|
New 6 Position Spinner works great
Just loaded up my new spinner with the 1st batch of 6. I find I can only Etex 2 at a time before the viscosity gets too thick... glad I have a p1000 Pipetman to measure out 500-1000ul volumes... I cut the tips back and angle the end off the disposable tips and heat both the hardner and resin by placing them on top of my furnace... I may start keeping the cup in a warm water bath to keep the mixed etex at 80-85 degrees while I am applying it
The springs that Woody recommended are great- Thanks
|
Blond Terror
Threaded Mode