Water in Fuel

[KeyWest225]

Ran my motor at home for about 10 minutes - all was good. Launched the boat in a lake for a 1 hour cruise to make sure it was sea worthy after sitting all winter. After about 3 minutes, my 2006 Verado started to shake and warning lights on gages indicated "water in fuel". I called my marina and they told me to empty the water/fuel separator and to drain the VST (vapor separator tank). Anybody ever done this before who can lend me some advice?? I hope to work on this before the weekend - I hear fish calling my name. Any help will be appreciated. Thanks.

[missing link]

EZORB & fresh gas EZORB changes Phase seperartion so it can burn
LINK

[Rip Runner]

You will want to do both what your marina told you and what missing link said and add EZORB. If you have a fuel filter with a bowl on the bottom and a valve, just drain the water into a cup. If you don't I would suggest getting one, or keeping an extra filter aboard at all times. I'm not sure about your boat but the access to the filters is usually pretty easy, maybe some bloody knuckles, but it's not a difficult job.

[wrench]

Key,

The water in fuel sensor is in the on engine fuel filter on the starboard side of the engine. The filter is red castle shaped and needs to greased with a silicone grease when reassembling to prevent it seizing from the ethanol.
The VST tank is on the rear of the engine, you will need to remove both the upper and lower engine covers and take off both side chaps to get to the drain.

Mike

[Van]

Go here and ask, that board has a lot of sharpies.
Or do a search there. Great site.

http://bbcboards.zeroforum.com/zeroforum?id=53

[KeyWest225]

Many thanks to all of you. If it ever stops raining I'll get out there and give it a whirl.