|
I got a whole set of cove bits cheap on sale I think 3/4 and 7/8 are the ones I use most.... you can go shallow or deep...I cut and face angle the thru hole sometime need to be alittle more than 1/8 I use a nail to make the hole bigger so the small tit the bearing sits on fits in the thru hole...then I put the drill press base up so when in holding the popper with a leather gloved hand the tail of the popper hits the base, so if the face is 65 degrees cut I hold it, if I'm right 65 degrees or what ever it is that makes the popper face 180 (flat)degrees to the cove bit I never push up to the bit, I use the drill press to lower the cove bit into the face of the popper
|
Threaded Mode