Next, I do the swivel, weight, and eye-holes. I do this on the drill press using a simple jig to keep things lined up. The jig consists of a scrap piece of sheet metal attached to a section of 2x4. The 2 by is attached to another piece of scrap wood. The sheet metal slides into the lip slot on the blank. When placed on the drill press, the blank will be held straight. Drill a 5/16 inch hole, ¼ inch deep for the weight. Drill the hole for the swivel next. I like the eyes just above the center line, so that is how I’ll mark, then drill the holes (3/8 in this case). I use forstner bits for the weight, swivel, and eye holes (yes, that is a brad point bit in the photo, I cheated for the photo
).
Threaded Mode