|
I stick a section of wire into the tail so I have something to hold while painting etc. The wire is crimped on the end inserted in the plug and bent over at the other end to allow for hanging the plug while drying.
Now its time to seal the plug. I use a mix of boiled linseed oil and mineral spirits (60% linseed, 40% spirits). I use a section of PVC pipe with ends on and a clamp to hold it the mix up right. Dip the plug for 30 seconds, let the excess drip off, then wipe the plug with a rag and hang to dry (be sure to read the warnings on the linseed label for proper disposal of the rags). After the sealer has dried, you can epoxy the weight in the plug. I have a mold set up to make my own, but you can use egg sinkers, buckshot, etc. Njtackle.com also sells some slugs for plug making too.
|
Hybrid Mode
