Nebe's right! I use the little clear plastic condiment cups that iParty sells. Just pour parts a and b to the exact same level in separate cups and the e-tex always comes out hard as a rock.
He that would make his own liberty secure, must guard even his enemy from oppression; for if he violates this duty, he establishes a precedent that will reach to himself.
Thomas Paine
Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there.
Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..
Mike at M&D's usually has syringes you can use for measuring the epoxy. I believe the tips of them are 3/32". Anyways take a drill bit and drill a hole in the cap of both the resin and the hardener that matches the tip of the syringe, pop the syringe in the hole (it's a tight fit) and leave them in there.
Then you just tip the bottle upside down and load as much as you want. Perfect every time. Learned this trick from a rodbuilding friend..
Great idea , I've got the syringes but couldn't figure a good way to draw out of 16oz bottles .
Thanks
Hybrid Mode
