but...one morning after i moved to the country
i decide to make sure my lathe is ok....
and i put my face up to the hole by the motor
as i want to listen closely to the ball bearings
and or determine if theres anything wrong....
i reach over and flip the switch and kapow
a freakin mouse shoots out of there into my face....
scared the heck outta me....
AH I've had a few break over the years. They will scare the crap out of you. This one was the biggest I've ever had, sometimes you can tell when they are about to break as they go chink chink chink as they spin, this one just went BAM and broke. I've never had one come out of the machine but have heard of others who have and it's not a pretty sight.
Raven I've had to clean out 3 nests this year in my truck engine compartment, luckily the little bastids haven't chewed anything. yet.
Once at work notices this new valve was leaking, got the ladder to check it out found that the someone had put a valve rated for 400 lbs in a 900 lbs line why it never let go. We could nver figure out. ThomT
the main thing is
I've had to clean out 3 nests this year in my truck engine compartment, luckily the little bastids haven't chewed anything. yet.
Hybrid Mode
