Keepin learnin--

[numbskull]

If you are using Createx, just take them to the sink, run hot water over them, and wipe em clean. Works even if they've dried, although in that case a scotchbrite pad helps. This will leave your primer intact and you can repaint, usually without resanding, in an hour or less.

If you are using spray cans, I've had success just spraying on a heavy coat of Krylon clear, letting it sit for a few seconds, then wiping with a coarse scotchbrite stripping pad and paper towel. You'll have to repeat a couple of times, but the Krylon softens the paint quickly and you can get a plug back down to primer pretty fast. The fumes also make you forget how mad you are. After this, I let it dry an hour, sand lightly, reprime and go from there.

So far I've had lots of practice with both techniques. Its worked with both Zissner Cover Stain and Zspar marine enamel undercoat as my primer.

[capesams]

wil-bond.....wipe an done....zip-zip.

[Tagger]

or just smash them with a hammer,,drop a few f bombs,, and kick a kitten .

[ProfessorM]

Originally Posted by Tagger

kick a kitten .

I got one to boot if you need it.

[Charleston]

Originally Posted by Tagger

or just smash them with a hammer,,drop a few f bombs,, and kick a kitten .

Dude!? you get thrown out of bed or something?