Froze steering

[ScottC]

Originally Posted by Professor Moriarty

Yup I got large nuts, not me the motor.

then that is your pivot tube, and it baffles me that Honda did not put grease fittings in there! Are you sure there is none underneath? if you take the pivot tube off the whole engine drops off, so you will either have to take the engine off the transom, or find some way to secure it with a jack underneath, you will have to take the load of the tube to slide it out as well. OMC tubes go for about 60 bucks, I have never done a Honda one so I do not know exactly what is involved.

[ProfessorM]

I will take picture and look for fittings tomorrow. I need to look at problem a little closer. This problem is all new to me. Thanks for your insight. Tomorrow. Screw it I am going out there right now with a flashlight to see if I can find any fittings. I will post tomorrow. Thanx. Paul

[ScottC]

Originally Posted by Professor Moriarty

I will take picture and look for fittings tomorrow. I need to look at problem a little closer. This problem is all new to me. Thanks for your insight. Tomorrow. Paul

Yeah take a long hard look and do like striperman36 said and dissconnect the steering from the motor to make sure it is a steering issue and not a motor issue. Then if you eliminate the motor as the problem, dissconnect the cable from the helm and make sure it is a cable problem, not a helm problem. this is all easy to do so don't worry.

[fishaholic18]

Cut cable at motor, slide shaft out of motof, disconnect at helm, duct tape new cable to old cable at motor side and pull whole thing thru from helm end.

[ScottC]

Originally Posted by fishaholic18

Cut cable at motor, slide shaft out of motof, disconnect at helm, duct tape new cable to old cable at motor side and pull whole thing thru from helm end.

In most cases you do not want to do that, your steering is stiff and unruley and usualy tied to your wiring, and on most smaller boats you can just drop everything down and carefully remove the steering cable and pop a new one in with less hassle. Trying to mouse the cable could damage the wiring.

[fishaholic18]

Originally Posted by ScottC

In most cases you do not want to do that, your steering is stiff and unruley and usualy tied to your wiring, and on most smaller boats you can just drop everything down and carefully remove the steering cable and pop a new one in with less hassle. Trying to mouse the cable could damage the wiring.

Done it many times with no problem. Have to make sure wiring is out of the way and not attatched to cable(common sense). Only way to do it on CC when cable is under deck. Paul. check your PM.

[ScottC]

Originally Posted by fishaholic18

Done it many times with no problem. Have to make sure wiring is out of the way and not attatched to cable(common sense). Only way to do it on CC when cable is under deck. Paul. check your PM.

Oh his is under the deck? I was under the impression his was rail mounted.