Can you help me ? My hole is crooked ...

[fishaholic18]

Originally Posted by Tagger

Bill,,,I ripped some pine 45 degrees on the table saw and glued and screwed it to the plywood..I clamp that in place on the bandsaw table centered on the blade... push whatever I want to split through.. falls off other side .. I also have an off center placement on this board I set up to do lips on round stock ..

Still don't get it? The V-jig thing that is, can u do a close up pic Ed?

[Tagger]

I just threw it on the table... I clamp it in place when I use it.. U can use to for drill press too ... dowels ..

[fishaholic18]

So, the V-block stays there and you push the plug thru it.
I get it now. Thanx

[justplugit]

Eddie when your pushin a danny or surfster thru the block to do the lip how are you holdin the uneven plug to prevent the chatter.
Thanks.

[Tagger]

Originally Posted by justplugit

Eddie when your pushin a danny or surfster thru the block to do the lip how are you holdin the uneven plug to prevent the chatter.
Thanks.

sorry,,have slotted dowels,, hydro orien presents new problems from working with square stock.. probably make a jig for that ,,holds plug on its side,,,start with prophile block like above.

[justplugit]

Thanks, prolly right Tagger, i use a scroll saw to cut my lips, which is fine for square, but turned pieces chatter hitting the top fence and denting the red ceda. Band saw being more powerful would be a better option too i guess.

[Tagger]

Originally Posted by justplugit

Thanks, prolly right Tagger, i use a scroll saw to cut my lips, which is fine for square, but turned pieces chatter hitting the top fence and denting the red ceda. Band saw being more powerful would be a better option too i guess.

Dave I have a schroll saw covered in dust from my band saw.. Thing is too jerky for me ... Bandsaw in smooth ..