Calcutta Repair

[eelman]

Quaker lane repairs Calcuttas.........

[Mike P]

You might just have some grease or oil in the anti-reverse bearing. Sometimes that can cause it to slip.

The bearing is stainless steel needles set in plastic, and the plastic has been known to crack from time to time. If a cleaning doesn't fix it you may need a new bearing.

[Roseneath]

It was slipping a few weeks ago, but last night it completely went. I guess I should have seen this coming

I'll take a look at the bearing this afternoon.

[numbskull]

Originally Posted by Mike P

You might just have some grease or oil in the anti-reverse bearing. Sometimes that can cause it to slip.

The bearing is stainless steel needles set in plastic, and the plastic has been known to crack from time to time. If a cleaning doesn't fix it you may need a new bearing.

Bucko's has the bearing. About $18 as I recall. Takes about 2 minutes to change it. It is a press fit into the right side cover plate.

[Roseneath]

Four years of chemical engineering - passed

Dismantle and repair reel - failed (miserably)

I cleaned the anti-reverse bearing, which helped a little, but I lost the main bearing as I was moving everything from the garage to inside the house, I wasn't paying attention and it must have fallen out. And on top of that, the shaft is not engaging the spool.

I brought the reel to the SWE and they are sending it to Shimano.

Now I have to come up with a back-up plan for the next few weeks. I'd like another Calcutta, but I also wouldn't mind getting a spinning set-up for when my father is in town... either way its going to cost some coin to get me through the next few weeks.

Another option is to ride it out, but I think I would have significant withdrawls... the winter is bad enough, and there aren't even fish around (besides holdovers).