I can't cut straight with my bandsaw!!!

[numbskull]

You need to tune a bandsaw to get it to cut right.
First, take off the covers and without a blade on it adjust the top wheel in or out so it aligns with the bottom wheel (use a long straight edge)
Next, put on a blade and spin it until it tracks on the crowns. Then shim the table to get it square.
Then, adjust your guides to a dollar bill thickness clearance right and left.
Bring the thrust bearings to just touch the rear of the blade.
Next tension your blade tight. On small saws it is best to use a thin blade 1/4-1/2" since the saws lack the guts to tension a wide blade.
Now cut a piece of wood and watch how the blade wants to track (very few track straight). Clamp the wood to the table and adjust your fence to be paralell to the cut piece. That should do it.