John, How did you mount the dup on the back? When I tried the tail stock got in the way. Or maybe it was the tail stock lever thingie Been a little while.
Bill, hose clips. No banjos at my house Accomplishes the same thing, just not as pretty as the set up paul did for you.
John, How did you mount the dup on the back? When I tried the tail stock got in the way. Or maybe it was the tail stock lever thingie Been a little while.
Bill, hose clips. No banjos at my house Accomplishes the same thing, just not as pretty as the set up paul did for you.
Jigman
I haven't even dusted it off yet this year but if I remember correctly, the tail stock only gets in the way of the bracket when you want to turn shorter blanks (<6" or so). I rarely make small plugs so this isn't an issue for me. It's been almost a year since I set it up so it's a little fuzzy. I do know that the mounting bracket is on the inside of the tailstock. I'll try to get a peek at it in the next few days and let you know if I did anything out of the ordinary but I don't think so. I just used the adjustment they gave me.
Thanks John. I do a lot of stuff that is smaller than 6 inches, so that might be the problem. No biggie. I have my older grizzly lathe still for protos and one offs plus the clamps on the vega allow me to take it off and on in minutes if need be.
Been a little while.
Accomplishes the same thing, just not as pretty as the set up paul did for you. 
Hybrid Mode
