|
I think you should go with one that rotates on wheels smoothly. Much better than the Vblock wrappers, especially where you're building 8-10 foot rods...
Personally, I'm going to build one on an 8-9 foot alignment board with 4 moveable stands with wheels (rollerblade or skateboard style) that lines up with my dryer motor. I also am going to run a thread carriage parallel to the wrapper but not directly connected to it. this will allow the carriage to slide where I want it to easily without needing to remove it to get on another side of the rod stands... I was going to start this weekend but too ill... Maybe this coming weekend :P
|
Threaded Mode