Pichney Danny Guts

[Slipknot]

I have had an idea to rout the hole in the belly of plugs with the kind of bit that you use to hang a picture with, it is T shaped and leaves a slot, this way the lead does not have to be so deep that it hits the thru wire and follows it as you pour it in, and also because of the way it's done it can never fall out. I suppose it has to be for large plugs only because that bit is good size.

I think the way that offset wiring is done, is done that way to keep the swivels at a certain height so they are even and don't stick out too far.
I did that on a small danny long ago.

good stuff George