Making Mack Stripes

[scottw]

I'm spraying some right now...pretty good result..much better than all previous attempts of mine, I'll take some more process pics when I get this one wrapped up...

[Raven]

thanks ScottW mighty nice of ya

[scottw]

they came out OK, it was fairly easy and not as frustrating as previous attempts at this...I will add the steps w/some pics...but I used powerpoint to get the image the way that I wanted it....printed it, cut it out and taped it to the plug body with scotch tape...applied the latex mold...you can use a brush but it will clog up as you go along so something small and blunt is better, like the opposite side of a fine paintbrush depending on the detail...let each coat dry...several coats.. 3 or 4....powder it a little before removing so it doesn't stick to itself...I imagine you can make all sorts of patterns by printing them from images.....

[smac]

Very cool!

[spence]

Funny, I'd just use a paintbrush

-spence

[transitdynamics]

sweet, much better then mine, i used a old bicycle tube and cut it out with scissors...