Minor details I can't seem to find

[Zeal]

Originally Posted by numbskull

Maple or birch for needles/darters
AYC/AWC/Pine/Basswood for swimmers/pencils/spooks
AYC/maple for jointeds
You will build much better plugs if you learn to weight them, although darters usually don't require it.

Depth control on plugs is dependent on many factors....not just the wood used.

I understand the depth control variables, the main concern is that heavier wood = sinks more than wanted with hardware on it and heavily affects the motion.

I know it sounds odd, but I have a bunch of split shots laying around, would using them as the lure weight be feasible (sorry I watched a lot of Macguyver growing up)?

Adding weight, you put weight in the tail for the lures including the darters or you need weight in the belly as well?

This advice is really great, I really appreciate it.

[Tagger]

Originally Posted by Zeal

I understand the depth control variables, the main concern is that heavier wood = sinks more than wanted with hardware on it and heavily affects the motion.

The farther back you put the line tie, the more a darter will dive also .. Well sought after Musso/Pichney darters were unweighted . Hate to sound like a broken record but if you do go the unweighted route might consider hydro orientating .. damm .. opened that can of worms again ..

Yes Paul,, I I think thats the size .. I know that PNG guy a little ...

[ProfessorM]

Originally Posted by Tagger

T

Yes Paul,, I I think thats the size .

I will send you the original with the weights, disassembled. I'll put in mail this week. I am sure VB won't mind as it is a beater. You can give it back at plugfest and someday I may even give it back to Peter. It really is a nice deep swimming plug. I made mine out of AYC.

[Zeal]

Originally Posted by Tagger

Hate to sound like a broken record but if you do go the unweighted route might consider hydro orientating .. damm .. opened that can of worms again ..

By Hydro orientating you mean shaping the blank piece of wood, sealing (if you prefer it), and then putting it in water to see where the top and bottom of the lure is before you put hardware on?

I've been thinking about basically shaping the lure (including making the head slope down since we are talking about a darter in this case), sealing it to avoid water absorption, and rubber banding the hardware on it and dumping it into a bucket/tub/tank etc. to see what happens before you go any further.

Am I just thinking into this too much or asking the wrong question? Process of building the lure out of order?